Pass4Test ist eine Website, die den Traum vielen IT-Fachleuten erfüllen kann. Wenn Sie einen IT-Traum haben, dann wählen Sie doch Pass4Test. Die Schulungsunterlagen zur EMC E22-275-Prüfung von Pass4Test sind von vielen IT-Fachleuten begehrt, die Ihnen helfen, die Zertifizierung zu bestehen und im Berufsleben befördert zu werden.
Nun ist die EMC E22-275 Zertifizierungsprüfung eine beliebte Prüfung in der IT-Branche. Viele IT-Fachleute wollen das EMC E22-275 Zertfikat erhalten. So ist die EMC E22-275 Zertifizierungsprüfung eine beliebte Prüfung. Das EMC E22-275 Zertfikat ist sehr hilfreich, um Ihre Arbeit in der IT-Industrie zu verbessern und Ihr Gehalt zu erhöhen und Ihrem Leben eine gute Garantie zu geben.
Mit der Entwicklung der IT-Industrie nimmt die Zahl der IT-Lerner seit Jahren immer zu. Das führt zu immer stärkerer Konkurrenzen. Und es ist undenkbar, dass Sie in IT-Industrie von anderen überschritten sind. Deshalb sollen Sie Ihre Fähigkeit ständig erhöhen und Ihre Stärke zu anderen beweisen. Wie können Sie Ihre Fähigkeit zu anderen beweisen? Immer mehr Leute wählen IT-Zertifizierungen, Ihre Fähigkeit zu beweisen. Wollen Sie auch die Zertifizierung? Kommen Sie zuerst zu EMC E22-275 Zertifizierungsprüfung. Das ist die wichtigste EMC Prüfung und auch von vielen Unternehmen anerkannt.
Exam Code: E22-275
Prüfungsname: recoverpoint backup and recovery specialist exam
Aktulisiert: 2014-02-16
Nummer: 126 Q&As
Die EMC E22-275 dumps von Pass4Test können Ihnen helfen, diese Prüfung sehr einfach zu bestehen. Außerdem, wenn Sie zum ersten Mal diese Prüfung teilnehmen, können Sie diese dumps von Software-Version benutzen, weil es ist eine Software, die für Sie die Inhalte und die Forme der aktuellen Prüfung simulieren. Sie können sich die aktuelle Prüfung zuvor fühlen. Danach können Sie sich nicht nervös fühlen bei der aktuellen Prüfung. Sie können auch sehr sorglos an dieser Prüfung teilnehmen. Und es ist auch wichtig für Sie, Ihr normales Niveau in der Prüfung zu erhalten.
E22-275 prüfungsfragen Demo kostenlos downloden: http://www.pass4test.de/E22-275.html
NO.1 Which device allows the installation of a Brocade splitter into a DCX director?
A. PB-48k-18i
B. PB-48k-AP
C. PB-DCX-32P-E
D. PB-DCX-48P-8G
Answer: B
EMC E22-275 E22-275 E22-275
NO.2 You want to upgrade a RecoverPoint environment using Deployment Manager (DM). As a prerequisite
to continuing with the upgrade, which TCP port needs to be open between the management station where
the DM is installed and the RPA management IP addresses?
A. 22
B. 23
C. 80
D. 161
Answer: A
EMC E22-275 E22-275 E22-275 originale fragen E22-275 antworten
NO.3 When installing a Microsoft Windows kdriver splitter, you receive the dialog box shown in the exhibit
and the installation stops.
What must you do to recover the installation?
A. Click Next, correct the SAN issue, and run SAN Diagnostics again
B. Click Next and Accept the SAN issue warning to continue the installation
C. Click Next to resume the installation with flags
D. Click Back to reconfigure the kdriver parameters
Answer: A
EMC E22-275 E22-275 testantworten E22-275
NO.4 Which generation of RecoverPoint Appliance hardware must be used to ensure you can use a CRR
over FC configuration?
A. Gen2 and 3 only
B. Gen2 and 4 only
C. Gen2, 3, and 4
D. Gen3 and 4 only
Answer: D
EMC E22-275 E22-275
NO.5 Refer to the Exhibit.
You are troubleshooting High Load activities on two consistency groups (CGs). As part of your tasks, you
have run the data collect and are reviewing the system log files for the CGs.
What is a possible root cause for this High Load period?
A. The preferred RPA has lost communications with the remote RPA and caused a failover of the CG
within the cluster.
B. The local site has lost connectivity to the remote site and caused the CG to go into Marking mode.
C. There is no journal assigned to the CG in the local site, causing latency build up during data transfer.
D. The copies are cross-connected between the sites causing additional I/O to flood the connectivity
between the sites.
Answer: A
EMC dumps E22-275 prüfungsunterlagen E22-275 prüfungsunterlagen
NO.6 In a Brocade splitter implementation using frame redirect mode, how many DPCs are available?
A. 1
B. 2
C. 3
D. 4
Answer: B
EMC prüfungsunterlagen E22-275 prüfungsunterlagen E22-275 zertifizierung
NO.7 You have finished deploying SANTap in a RecoverPoint CRR environment. At Site 2 everything looks
fine. However, at Site 1 you see the following message on the RecoverPoint Management Application:
WARNING: RPA cannot access discovery AVT: 7001248288220000 ; Site1 ; RPA1 in Site1 ; Cisco -
CVT22-2109000dec3c3182
You have checked that back-end and front-end VSANs are properly configured with the correct members
in each. Which action can you take to perform a full discovery of ITLs and recreation of AVTs to fix this
issue?
A. SSH as 'admin' and run the refresh_santap_view command
B. Refresh the splitters on the RecoverPoint Management Application
C. Rescan the SAN on the RecoverPoint Management Application
D. SSH as 'admin' and run the get_santap_view command
Answer: A
EMC zertifizierungsfragen E22-275 E22-275 prüfungsfragen
NO.8 You are finalizing a RecoverPoint setup that makes use of the Symmetrix VMAXe splitter. You are about
to create the masking view for the RecoverPoint cluster initiator group.
Which setting must be enabled to allow the RPAs to write to the replica volumes when image access is
disabled?
A. Write Protect Bypass
B. Always Push Old
C. Backlog Mirroring
D. Device Tagging
Answer: A
EMC E22-275 echte fragen E22-275 testantworten E22-275
NO.9 You have a customer with an EMC VNX array at each site that uses both block and file storage. They
would like to use the VNX splitter to replicate all their iSCSI data LUNs.
How would you configure RecoverPoint?
A. Use the Consistency Group Wizard to create a CG
B. Use Installation Manager and "Expose" all iSCSI LUNs
C. Check the "Enable iSCSI Replication" option in the CG profile
D. Replication of iSCSI LUNs are not supported at this time
Answer: A
EMC E22-275 prüfungsunterlagen E22-275 testantworten E22-275
NO.10 Refer to the Exhibit.
You are troubleshooting a RecoverPoint issue where consistency groups, using a kdriver splitter, have
stopped working. While analyzing the problem, you ran detect Fibre Channel targets from the SAN
Diagnostics menu. What does this output tell you that relates to the problem in the environment?
A. RPA is not zoned to any hosts
B. All RPA HBA ports are being used as targets
C. Even and odd ports should not see the same targets
D. Ports 0 and 3 should not be connected to the same fabric
Answer: A
EMC zertifizierungsfragen E22-275 testantworten E22-275 prüfungsfragen E22-275 exam fragen
NO.11 You have just enabled the zones and re-enabled the configuration on a AP-7600B switch. Where would
you run the thirdparty/recoverpoint/install/kdrv status command to verify the status of the kdriver on the
switch?
A. As root in the blade processor
B. As admin in the blade processor
C. As root in the control processor
D. As admin in the control processor
Answer: A
EMC echte fragen E22-275 originale fragen E22-275 zertifizierungsfragen E22-275 antworten E22-275 zertifizierungsfragen E22-275
NO.12 A customer wants to add a new RecoverPoint UserID. Which role must their UserID belong to in order to
manage user settings?
A. Security
B. Admin
C. Boxmgmt
D. Monitor
Answer: A
EMC E22-275 E22-275 E22-275
NO.13 A customer has a RecoverPoint environment defined with two RPAs at each site. They created two
consistency groups (CGs), each one in a different RPA. Their business requires that both consistency
groups act as a single unit as they are dependent on one another.
How can they achieve this requirement?
A. Create one Group Set for both CGs
B. Enable the RecoverPoint Snapshot Consolidation feature
C. Select the same primary RPA for both CGs
D. Configure distributed consistency groups
Answer: A
EMC E22-275 E22-275 E22-275 E22-275
NO.14 A customer is planning to deploy a 2-node RecoverPoint cluster at each data center. They will make use
of dual stack for its LAN network connection.
How many IP addresses should the customer plan for per site, including management IP addresses.?
A. 5
B. 6
C. 7
D. 8
Answer: D
EMC E22-275 prüfung E22-275
NO.15 You are implementing a RecoverPoint CRR solution. The RPAs that were delivered do not have the
correct version of RecoverPoint.
What is the EMC-preferred way to load the correct software version to the RPAs?
A. Before launching Deployment Manager
B. During the Deployment Manager installation process
C. After completing the installation but before the license is installed
D. After the installation is complete
Answer: A
EMC prüfungsfragen E22-275 zertifizierungsfragen E22-275 E22-275 E22-275 zertifizierung
NO.16 You are installing the RecoverPoint splitter agent on a B-Series switch. After downloading the agent
binary file to the blade processor, which step must be completed prior to successfully running the
command?
A. chmod +x agent_binary_file
B. chmod +rw agent_binary_file
C. /thirdparty/recoverpoint/install/zoning_script.sh
D. /thirdparty/recoverpoint/install/kdrv start
Answer: A
EMC E22-275 E22-275 echte fragen
NO.17 You have installed the Solaris kdriver on a host. When validating the installation, you find that the
splitter is not seen by the RecoverPoint Management Application. Other splitters appear correctly in the
GUI.
Which step should you take on the host to discover the splitter by the GUI?
A. Run the /etc/init.d/kdrv start command
B. Run the rc.kdrv configure command and restart the kdriver
C. Run the rc.kdrv start command and reboot the host
D. Run the devfsadm command
Answer: A
EMC E22-275 E22-275 E22-275
NO.18 In a cascaded RecoverPoint configuration, a customer experiences a site failure at the secondary site.
What impact does this have on replication?
A.Site 1 to Site 2 replication fails Site 2 to Site 3 replication fails
B.Site 1 to Site 2 replication fails Site 2 to Site 3 replication continues
C.Site 1 to Site 2 replication fails Site 1 to Site 3 replication continues
D.Site 2 to Site 3 replication fails Site 1 to Site 3 replication continues
Answer: A
EMC E22-275 echte fragen E22-275 prüfung
NO.19 What is the blade processor in a Brocade splitter?
A. A separate command shell which loads and operates the splitter
B. A special slot in a Brocade director with intelligent switch capabilities
C. A daughterboard in the switch to allow RecoverPoint integration
D. A dedicated memory space in the RPA to integrate with a Brocade switch
Answer: A
EMC E22-275 zertifizierung E22-275 zertifizierungsantworten E22-275 prüfungsfrage
NO.20 You are selecting the RecoverPoint repository volume using Deployment Manager at a customer's site.
If the customer's environment makes use of an EMC VNX array, what needs to be considered?
A. Selected LUN will be formatted
B. Use of a thin provisioned LUN is supported
C. LUN is accessible by only one RPA
D. Thin LUNs have to be pre-allocated
Answer: A
EMC E22-275 zertifizierungsfragen E22-275 antworten
Pass4Test bietet Ihnen die neusten 1z0-599 exam Unterlagen und 78-702 pdf Fragen & Antworten mit hoher Qualität. Unser CV0-001 zertifizierung und 000-400 prüfung Lernführung können Ihnen hilfen, die aktuellen Prüfungen zu bestehen. Hochqualitative C-HANATEC131 dumps Training Unterlagen können Ihnen gewährleisten, leichter und schneller, diese Prüfung zu bestehen. Es ist sehr einfach für Sie, die Zertifizierung zu bekommen.
Artikel Link: http://www.pass4test.de/E22-275.html
没有评论:
发表评论